Categories

Categories

Account Navigation

Account Navigation

Currency - All prices are in AUD

Currency - All prices are in AUD
 Loading... Please wait...
ethosleather.com

Categories

Categories

Gunslinger Harness

$70.00

Gunslinger Harness

$70.00
Availability:
N
Quantity:
Share

Product Description

Our Gunslinger harness was designed for a clean but very masculine look.  1.25" wide latigo leather straps are curved just right to lay flat against your body and stay comfortable all night.  Without any buckles or snaps it uses stainless steel Chicago Posts (screw fasteners) for adjustment/fitting (fits XS-XXL).  This harness, like all of our harnesses, is designed just as much for wearing out to the bar or event as it is for fucking.  The snap-less design will permit for some very rough pulling and thrusting, for years to come.  The optional belt strap does use a snap for ease of attaching to your belt.  Harness is constructed of sturdy 8-10 ounce black latigo leather.  All materials are domestically sourced and gear is handmade in Central Maine.

 

Fitting Instructions:

Using a flat-head (preferably #2) screwdriver (not provided) to remove the Chicago Posts.  Note: the long legs of the center piece point down and the makers mark on the straps goes above the center piece.  Use the following fitting chart to determine where the straps should be set on the center piece by counting how many holes are exposed past the end of the center piece:

Chest Size:

28" No hole showing on top, no hole showing on bottom

30" No hole showing on top, one hole showing on bottom

32" One hole showing on top, one hole showing on bottom

34" One hole showing on top, two holes showing on bottom

36" Two holes showing on top, two holes showing on bottom

38" Two holes showing on top, three holes showing on bottom

40" Three holes showing on top, three holes showing on bottom

42" Three holes showing on top, four holes showing on bottom

44" Four holes showing on top, four holes showing on bottom

46" Four holes showing on top, five holes showing on bottom

48" Five holes showing on top, five holes showing on bottom

50" Five holes showing on top, six holes showing on bottom

52" Six holes showing on top, six holes showing on bottom

Temporarily install one screw post at each outside hole of the center peice according to the above chart.  Try the harness on, wear

it for a few minutes, walk around, bend over, turn side to side.  If it needs to be tighter or looser then adjust as needed.  Be sure to

adjust both sides so they match.  The difference in the number of holes showing above and below the center peice should not be

more then one ie: you should not have four holes showing above the center piece and one hole showing below the center piece.  Once you

are satisfied with the fit, install the remaining four screws, two screws per side, both in the bottom strap.  The top strap is only held in

with one screw.  The total of three screws in the bottom strap give you up to 4" of chest growth space if needed for later adjustment.

Once all of the screws are in, try it on again and wear it for awhile. Once you are sure you are happy with the fit cut the excess straps

off.  You can use medium strength loc-tite on the screw threads if you are concerned about the screws loosening up.

 

 

Specifications:
Package Contents: 1 Shoulder Harness or 1 Shoulder Harness plus Belt Strap or a separate Belt Strap.
Size: One size fits most, one time fitting required, XS-XXL, 28-52" Chest.
 
Materials (Black Model):
8-10 oz Black Latigo Leather
Stainless Steel Chicago Posts
Nickle Plated snap (only on belt strap)
 

Product Reviews

Find Similar Products by Category